Multiplexers
Extend your measurement channels
AM16/32B 16- or 32-Channel Relay Multiplexer
The AM16/32B multiplexer significantly increases the number of sensors that can be measured by a Campbell Scientific datalogger. It interfaces with the datalogger and adds...
AM25T 25-Channel Solid-State Multiplexer
The AM25T 25-Channel Solid State Multiplexer increases the number of thermocouples that can be measured by a Campbell Scientific datalogger. The multiplexer interfaces with the...
SDMX50 Coaxial Multiplexer
SDMX50LP Coaxial Multiplexer
SDMX50SP Coaxial Multiplexer
Resources and Links
About Multiplexers
Multiplexers allow our dataloggers to measure more sensors. The number of analog inputs is increased by sequentially multiplexing sensor leads into "common" leads. The individual common leads are connected to datalogger analog inputs, excitation channels, or ground as required by the sensor. The datalogger controls the multiplexer using two control ports or one control port and one excitation channel.
FAQs for
The CR200X-series and the retired CR200-series dataloggers are NOT compatible with SDMs or multiplexers. If you need more channels or might need more channels in the future, you should probably purchase a CR800, CR850, or CR1000 instead.
Feedback?