Sentek EasyAG System
A 50-cm probe for water content profiles
SEN12512 Water-Content Probe
The SEN12512 is an EasyAG probe with an SDI-12 interface and a 50-cm length. This probe provides water content profiles for cultivated soils of good...
SEN70508 EasyAG Installation Toolkit
The SEN70508 EasyAg Installation Kit includes a stabilization plate that helps to stabilize the auger so that it bores a hole perpendicular to the plane...
SEN70518 EasyAG Installation Auger
The SEN70518 auger bores a pilot hole for the installation of the EasyAG probe. The SEN70508 EasyAg Installation Kit, SEN06021 cable, and SEN6025 software are...
SEN70060 EnviroSCAN Installation Normalization Container
The SEN70060 includes a PVC sleeve that transects a container that can be filled with water. The EnviroSCAN is then inserted into the sleeve, allowing...
SEN06021 Programming Cable
The SEN06021 is a 6-ft cable. It is required for normalization and setup of an EnviroSCAN or EasyAG probe. The SEN70508 EasyAg Installation Kit, SEN70518...
SEN06025 Utility Software for EnviroSCAN or EasyAG
The SEN06025 software is required for the normalization and setup of an EasyAG or EnviroSCAN probe. To install an EasyAG probe, the SEN70508 EasyAg Installation...
SEN80127 Ferrite Bead
A SEN80127 ferrite bead is used with our EasyAG and EnviroSCAN probes. It is a hollow cylinder that reduces electromagnetic noise when looped into probe...
4091 Desiccant, 0.75-g Bag
The 4091 is a 0.75-g bag of desiccant for maintaining a noncondensing environment inside instrument housings of some of our products. For example, the EasyAG...
Resources and Links
About Sentek EasyAG System
EasyAG is intended for cultivated soils of good tilth, commonly found in vegetable production areas. It is unsuitable for stony soils where the average stone size is greater than 10 mm; EnviroSMART should be used for those applications.
Feedback?