03002-L

Mounting

The 03002 is supplied with a 12-in.-long x 1-in. IPS unthreaded aluminum pipe, which mounts to a crossarm via a CM220 Mount or 17953 NU-RAIL fitting. The 03002 can also be mounted to the top of a CM110, CM115, or CM120 stainless-steel tripod via the CM216.

Wind Profile Studies

An ideal application for the Wind Sentry is wind profile studies. For this application, the LLAC4 4-channel Low Level AC Conversion Module can be used to increase the number of anemometers measured by one datalogger. The LLAC4 allows datalogger control ports to read the anemometer’s ac signals instead of using pulse channels. Dataloggers compatible with the LLAC4 are the CR200(X)-series (ac signal ≤1 kHz only), CR800, CR850, CR1000, CR3000, and CR5000.

Datalogger Considerations

Programming

The anemometer is measured by the PulseCount instruction in CRBasic, and by Instruction 3 (Pulse Count) in Edlog. The wind vane is measured by the BrHalf Instruction in CRBasic, and by Instruction 4 (Excite-Delay-SE) in Edlog. The measurements are typically processed for output with the Wind Vector Instruction (not present in the CR500 or CR9000).

Compatible Contemporary Dataloggers

CR200(X) Series	CR800/CR850	CR1000	CR3000	CR5000	CR7X	CR9000X

Compatible Retired Dataloggers

CR500	CR510	CR10	CR10X	21X	CR23X	CR9000
*						*

*Measurements are typically processed for output with the Wind Vector instruction, which is not present in the CR500 or CR9000.